a5e4f70f

22:19. Handle of a forward door

Removal
Remove a door upholstery.
Remove an arm from a door.
Disconnect drafts from the cylinder of the lock and the handle of a door.

Fig. 16-34. Handle of a forward door: 1 – rotary clip; 2 – door handle; 3 – bolt, 5 N · m; 4 – a lock ring (on models till 02.96) or a clip (on models from 02.96); 5 – driving lever; 6 – spring; 7 – casing; 8 – plate; 9 – decorative overlay of the handle; 10 – sealing ring; 11 cylinder of the lock



Insert a key into the cylinder of the lock of a door and remove a lock ring 4 and a rotary clip 1 (see fig. 16-34) from the lock cylinder.
Remove from the lock cylinder the driving lever 5 and a spring 6. Take the lock cylinder together with a key and remove a casing 7.
Unscrew a bolt 3 fastenings of the handle of a door.

Fig. 16-35. Removal of a fixing strip of an overlay of the handle of a door



The small screw-driver squeeze out a fixing strip of an overlay of the handle of a door and remove a slip (fig. 16-35).

Installation
Installation is carried out to the sequences, the return to removal, taking into account the following.

Fig. 16-36. An arrangement of the ends of a spring (1) from two parties of a ledge of the driving lever (2)



At installation of a spring squeeze it and arrange the ends from the left and right side of a ledge of the driving lever (fig. 16-36). Preliminary compression of a spring provides return of the driving lever to average situation.

Fig. 16-37. Combination of a half of tooth on the lever and a half tooth on a microswitch drive gear wheel



Install the driving lever so that a half of tooth on the lever was combined and a half tooth on a gear wheel of the drive of the microswitch (fig. 16-37). It provides normal functioning of anticreeping system and system of the central blocking of the lock.