24:13. Headlights
|
Fig. 18-33. A headlight with a halogen lamp: 1 – headlight case; 2 – lamp of a fog light of H3 (12 V, 55 W); 3 – 5-contact electric socket; 4 – back cover of a headlight; 5 – lamp of driving beam; 6 – lamp of H1 passing beam (12 V, 55 W)
|
The device of headlights with halogen and gas-discharge lamps is shown in fig. 18-33 and 18-34.
|
Fig. 18-34. A headlight with a gas-discharge lamp: 1 – rubber slip; 2 – headlight glass; 3 – clip; 4 – laying; 5 – reflector frame; 6 – reflector; 7 – lamp of driving beam (12 V, 65 W); 8 – lamp lobby dimensional (12 V, 5 W); 9 – lamp of a fog light (12 V, 55 W); 10 – lamp of passing beam (gas-discharge 12 V, 35 W); 11 – spring holder; 12 – the control unit of a headlight with a gas-discharge lamp; 13 – Torx-bolt; 14 – back cover; 15 – plastic washer; 16 – bolt; 17 – laying; 18 – engine of the proofreader of light of headlights; 19 – consolidation; 20 – clamp arm; 21 – headlight case; 22 – block of activation of a gas-discharge lamp; 23 –;;;;;;;;;; 24, 25 – plaits of wires
|
Removal
Tape a bumper about a headlight not to damage coloring of a bumper.
Unscrew bolts of fastening of a front bumper and push it forward from an arm on 5–10 cm.
Remove indexes of turn.
Disconnect the 5-contact electric socket of a plait of wires of a headlight from a headlight.
|
Fig. 18-35. Elements of fastening of a headlight: 1 – screw; 2 – lower slip; 3 – bolt of fastening of a headlight
|
Unscrew four bolts 3 and take a headlight from the car forward.
Installation
Install a headlight on the car in such situation that the gap on perimeter of a headlight was identical.
Further installation is carried out to the sequences, the return to removal.
Check and if necessary adjust light of headlights.