21.5. Check of a rotor of the ABS sensor
Weaken bolts of fastening of forward wheels, then lift a forward part of the car and fix on supports. Remove a forward wheel.
Take the ABS sensor from a rotary fist.
|
Fig. 15-3. Check of a condition of a rotor of the ABS sensor through an opening for installation of the ABS sensor
|
Turning a drive shaft, through an opening for installation of the ABS sensor (fig. 15-3), gradually check an ABS sensor rotor for absence of damage and pollution.
In the presence of damages of a rotor it is necessary to replace the external CV JOINT of a shaft of the drive.
If the rotor of the ABS sensor is polluted, clear it of dirt. For access to a rotor of the ABS sensor unscrew a bolt of fastening of a shaft of the drive to a nave and move a shaft inside.
It is impossible to lower the car on wheels at all with the removed by two or one shaft of the drive as it will lead to damage of wheel bearings. If it is necessary to install the car on wheels and to move it with the removed drive shaft, instead of a shaft install the external CV JOINT and tighten a bolt of its fastening the moment of 50 N · m.
Establish a drive shaft in a nave and fix it by a bolt, having tightened the moment 190 N · m and having in addition tightened on a corner 180 °.