21:15. Lever of the parking brake
Removal
On all-wheel drive cars remove back section of system of release.
|
Fig. 15-38. An arrangement of bolts of fastening of a flange of the driveshaft to the main reverse gear and screws of fastening of the thermofilter
|
Unscrew screws and remove the central thermofilter (see fig. 15-38).
|
Fig. 15-33. Lever of the parking brake: 1 – decorative slip; 2 – facing of the lever of the parking brake; 3 – cover; 4 – central console; 5 – washer; 6 – screw; 7 – lever of the parking brake; 8 – handle; 9 – the self-cutting screw; 10 – switch of a control lamp of the parking brake; 11 – lock ring; 12 – spring; 13 – protective cover; 14 – hinged finger; 15 – compensator; 16 – plug; 17 – adjusting nut; 18 – hinged finger; 19 – clip; 20 – bolt, 5 N · m
|
|
Fig. 15-34. Unscrewing of an adjusting nut of fastening of the compensator and an arrangement of the springs fixing covers of cables of the parking brake
|
Unscrew an adjusting nut of fastening of the compensator to draft of the lever of the parking brake (fig. 15-34), remove the plug and the compensator.
Remove a protective cover from draft of the lever of the parking brake.
Remove the central console.
|
Fig. 15-35. Elements of fastening of the lever of the parking brake: 1 – bolt; 2 – clip; 3 – lock ring
|
Remove a lock ring 3 from a hinged finger and squeeze out a hinged finger.
Move the lever of the parking brake to a back part a little and remove it.
Installation
Installation is carried out to the sequences, the return to removal, taking into account the following.
Before installation of the lever apply G 000 150 lubricant on all mobile connections.
Establish a lock ring and check reliability of fastening of a hinged finger.
Establish a protective cover.
Check that the system was installed freely, without tension, with a sufficient gap from body elements.
Adjust the parking brake.